Support (Read Only) > Help

A question about a well needed replacement for wire hydraulics

(1/1)

StartedBullet:
Hello, I need a replacement in wire build for wire hydraulics. Wire hydraulics tend to act strange when weight is added to them, as is neccesary in some of my designs. I need a linear "Piston" that can move objects in relation to one another due to my E2 chip. Care to suggest any tools so I can make a prop machinegun?

    -Thanks

 

Peetah:
Ive have gone back into making engines.
It is not the Hydraulic that causes your problems, its were it is anchored.
I have built an engine using Mass center. Its dam near perfect.

Also change the Constraint and Dampening for more strength.
Found on the inputs of the Hydraulic controller.

ursus:
Back when I was actually productive in build servers, I had alot of issues with adv. duping hydraulics...

was this ever fixed?

StartedBullet:
Not for me.

Rocket50:
Hydraulics can be really stupid on some instances, where in others in works fine.

If you  can find a better one then by all means, go ahead

Navigation

[0] Message Index